article
EURAMET Met4Wind training course - 3D gear surface measurement development for wind turbines
EURAMET Met4Wind training course - 3D gear surface measurement development for wind turbines
Date: 3rd August, 2023
Venue: Online Teams training event hosted by the BGA
About the seminar
Developments in measurement technology now enable us to measure the 3D surfaces of gears, but how do we use the results? This short seminar will update you on research work undertaken in the EURAMET funded Met4Wind project and provide some suggestions. The methods are generic and applicable to all gear applications.
The sessions are pre-recorded so you can go through the material at your own pace reviewing or skipping material as required. A live Q&A session with the presenters will follow and we will also discuss future development plans . A PDF copy of the presentations will be available after the event those who register.
Agenda
09:15 – 09:30 | Welcome and introduction to this online 3D gear measurement course with instructions how to access the pre-recorded presentations | NCL |
09:30 – 11:30 | Pre-recorded technical presentations available for you to access individually.
|
PTB NCL NCL |
11:30 – 12:00 | Live Q and A session with the presenters and future development plans | NCL and PTB |
If you would like to register for this seminar please visit www.bga.org.uk or contact Kirsty & Lynne in the BGA office admin@bga.org.uk
You are welcome pass this information on to others who may also be interested.
We look forward to seeing you on 3rd August.
Kirsty McGregor
Senior Administrator
British Gear Association
0191 208 6160
British Gear Association
University of Newcastle upon Tyne
Unit B1 & B2
Wincomblee Road
Walker
Newcastle upon Tyne
NE6 3QS
