The project has been started 2008 within the presidency of Georges Roobaert, Hansen Transmissions Int.
The power transmission engineering industry is an important industry branch, universities fail to develop appropriate courses. In Europe, a mechanical engineer gets on average 5 hours of gear training. This is far too less to be effective in industry. Moreover, gear trainers are becoming rare due to retirement and non replacement. Therefore, EUROTRANS identified the remaining top gear trainers and developped an extensive modular Gear Training covering all aspects from geometry and design over production to quality control and failure analysis. Addressing an European audience, this residential training is organised in several locations in close connection with famous gear laboratories.
Training Program 2012 on Master Level (English spoken):
Geometry and design
When? 15 – 19 October 2012
Where? Munchen, Germany (in collaboration with FVA)
Please find the detailed programme for this week below. If you wish to subscribe, please use the subscription form at the end of this folder.
Room reservations should be made directly with the hotel using the separate reservation form to take advantage of the special Eurotrans rates.
Attached you will find the actual inscription form - please register soon!
Coordination: AGORIA / Belgium
Further information:
Dr Barbara Willems: Tel.: (+32 2) 7 06 81 45
mailto:barbara.willems(at)agoria.be
The first training sessions has taken place in January 2010. Eurotrans were pleased to welcome 15 particpants for the 1st week of the Eurotrans Gear Training on ‘Geometry and Design’ at Cetim (Senlis, France). The last trainings 2011 were evaluated again 'satisfying' to 'very satisfying' on the content of the courses and the organisation of the complete program.